[. . . ] Installation, Use Maintenance Manual OVEN HOOD K143X Introduction and The plug to be connected to the power cable must be compliant with the regulations in force. Use the hood at an ambient temperature between +5 °C and +35 °C. [. . . ] Installation All the materials, with the exception of silicone, used for installation must resist a temperature of 150 °C without generating strains and/or surface defects. 2. 1 - Positioning The Oven Hood must be positioned on the oven, after must be fixed the conveyor by screws , that will be fixed to the rear oven’s back (Fig. 1). Figure 1 2. 2 - Electrical connection The electrical connection, single phase 220 – 230 V ~ 50Hz, must be carried out by qualified personnel in compliance with the European regulations in force. If the plug is replaced, it must be compatible with the maximum power of the hood. It is recommended to have the installation done by a qualified electrician, in compliance with the regulations in force. – The equipment must be earthed properly according to the safety regulations of the electrical system. Page 1 of 3 2. 4 – Operation The Oven Hood will be turned on by the front switch (Fig. 2) cover Cover pannel Switch Switch Figure 2 Figure 1 Figura 2 3. – Before carrying out any maintenance operations, turn off the current by using the appropriate switch or disconnecting the plug. Attention!!!– When removing the panel, handle them with great attention by using gloves to protect hands from possible cuts. 3. 5 Spare parts 3. 1 – Disassembling labyrinth filters It is possible to use original or authorized spare parts only. [. . . ] – Never use detergents containing: sand, caustic soda, acids or chlorides that might corrode the surface. – Carry out any cleaning operation cutting off the power supply first The hood must be cleaned by using a damp cloth with nonabrasive detergent and drying the surfaces with a dry cloth. Figura 3 – Electrical connection. Page 3 of 3 [. . . ]